Raymarine ST70+ - Seatalk Ng Connections; Mounting & Connecting Products; Mounting Options

12 ST70+ User Reference Manual
SeaTalk
ng
connections
For each ST70+ product:
1. Locate a SeaTalk
ng
connection point within 400 mm of the intended location of the
product. This can be at any of the following:
•SeaTalk
ng
T piece.
• Spare SeaTalk
ng
connector on a product already installed.
•SeaTalk
ng
5-way connector block.
2. For each SeaTalk
ng
connection, label both ends of a SeaTalk
ng
spur cable, then
connect it to the connection point, and run the free end to the intended location.
Mounting & connecting products
Mounting options
You can either flush mount or surface mount your ST70+ displays and keypads.
Figure 2-2: Example of flush and surface mounting
Use the appropriate template to facilitate the installation of each product. Templates
for flush and surface mounting are provided as follows:
• Keypad templates are included at the end of this Installation Guide.
• Display templates are provided with each display, on a separate document
87107-1.
At each location, ensure that:
• The mounting panel is capable of supporting the product(s) you intend installing.
• The mounting surface is clean, smooth and flat.
• There is sufficient space behind the mounting panel to accommodate the rear of
the product and the connections to it.
D11387-1
Surface mount
Flush mount
87099_1.book Page 12 Thursday, March 12, 2009 10:18 AM