Chapter 3: Commissioning Procedures 31
3. When the
PORT
result page is displayed, press
either
•
OK
if the rudder moved to port, or
•
CANCEL
if the rudder did not move to port.
4. If you press
OK
a second
Motor Check
caution
page is displayed.
5. If it is safe to proceed. press
OK
, then check
which way the autopilot drives the rudder.direc-
tion.
6. If you press
OK
a second
Motor Check
caution
page is displayed.
7. When the
STBD
result page is displayed, press
either
•
OK
if the rudder moved to starboard, or
•
CANCEL
if the rudder did not move to star-
board.
8. If you press
OK
a task complete page is dis-
played.
9. Press
OK
to end the autopilot dockside wizard.
Hard over time
Note: Not applicable to boats with a rudder reference transducer.
On boats without a rudder reference transducer, it is of critical importance to set the
hard over time, to ensure accurate autopilot operation. To do this:
At a convenient Pilot Controller:
1. Press
MENU
to display the
Main Menu
.
2. Scroll to
Autopilot calibration
then press
OK
to display the
Autopilot Autocalibra-
tion
menu.
3. Scroll to select the
Drive settings
option then press
OK
to display the
Drive settings
menu.
i
Press OK for YES
Motor Phasing Non-referenced
Did the rudder move to PORT?
Press CANCEL for NO.
D11613-1
Please press OK if it is safe to
engage the rudder drive in
the opposite direction.
Motor Check
Press CANCEL to stop
D11617-1
i
D11618-1
Press OK for YES
Motor Phasing Non-referenced
Did the rudder move to STBD?
Press CANCEL for NO.
i
Motor Check
Press CANCEL to stop
Task Complete - success
D11613-1
87099_1.book Page 31 Thursday, March 12, 2009 10:18 AM
To Next Page
Loading...
