Operator manual
110--233
STD22 Compact and STD22
36
3646/110 --233.DOC010102 Edition: Feb. 17, 2006
4 Alarm signalling (in the event of an error)
Alarms are indicated on the compass as follows:
The course is not displayed, as well as at the connected heading receivers !
An alarm signal is indicated on the digital display by means of a flashing Erro (for Error)
(flashing “OFF”), flashing “OFF” occurs only when the voltage is too low.
After the blinking “Erro” the compass internal PC--board which fails and an error code is
displayed (detailled information --> see Service manual).
Figure 16 : Digital display for “error indication”
To Next Page
Loading...
Need help?
General
