M 20X Digital Mixer Reference Guide
SENDS
For each input channel, the SENDS page allows to control all channel sends to every mix bus: FX [1-4], MIX [1-8], and
APFL. For each send-on-mix are available different parameters: Pre/Post, on/off and Level.
The encoder parameters change according to the selected block send-on-mix.
The SENDS parameters assigned to the Encoders are:
APFL channel send
PRE / POST
ON/OFF
4 FX channel sends
PRE / POST
ON/OFF
Level
8 MIX channel sends
PRE / POST
ON/OFF
Level
DCA and MUTE
GROUPS assignment
Select Send block by
moving Encoder 2
SEND SEL: this parameter allows to select the single send-on-mix block
PRE/POST: this parameter allows to select if the selected send-on-mix is Pre or Post Fader
ON/OFF: this parameter allows to enable or disable the selected send-on-mix
LEVEL: according to the send type, this parameter allows to set the send level in the range [-inf: +10] dB
To Next Page
Loading...
