M 20X Digital Mixer Reference Guide
CONFIG MIXER
M 20 digital mixers periodically (every 5
seconds) save the current configuration of the
machine. It’s possible program the start-up
mode of the mixer to recall last configuration or
to load the default values of console’s
parameters.
Holding FACTORY RESET button, the console
will be resetted to factory state.
WARNING: all saved SHOWS and PRESETS will
be erased and all configuration parameters and
processing parameters will be reset to default
values.
TALKBACK
Analog Channel 16 can be configured as Talkback source. Through the SYSTEM > TALKBACK page it’s possible setup
the talkback options.
Each custom fader can be configured to
control one of these faders:
IN [01: 20]
MAIN OUT L, MAIN OUT R
MIX OUT [01:10]
FX RTN [01:04]
FX SEND [01: 04]
DCA GROUP [01: 04]
Press CANCEL to return to CUSTOM
FADER page.
Choose your option directly scrolling on
the screen or using the Encoder 3 (LIST
SEL), then press OK to confirm.
Select the outputs where
automatically route CH16
when talkback is activated.
Adjust the global level of
talkback using Encoder 3
To Next Page
Loading...
Need help?
General
