69
E44
"ITEMS OVERFLOW [CL] "
It indicates it has reached the maximum number of items that
may be recorded onto the current receipt. Close the receipt
and open a new one to record the missing items.
E45
“CHANGE NOT ADMITED [CL] "
The closing total utilised is programmed not to accept any
change. Use another Total or re-program the one used.
E51
"FISCAL MEMORY ALREADY SET [CL] "
Performing the serialisation procedure is not possible (already
done by the manufacturer).
E52
"DATA NOT CLEARED [CL] "
It indicates that before continuing performing a fiscal daily
reportis mandatory.
E53
"PREVIOUS DATE [CL] "
It indicates that during the cash counter reinstatement, a date
prior to the last fiscal daily reporthas been entered.
E54
“NO DAILY REPORT [CL] ”
It indicate that you haven’t done the fiscal daily report about
the day before. Do a fiscal daily report.
E60
"PAPER OUT Press [CL] "
It indicates that the paper roll has finished. Replace the roll
paper as indicated in chapter 12 of the operating manual.
E61
“HEAD ERROR Press [CL] "
It indicates that the thermal head connector (printer) is
disconnected from the printer logic card.
E62
“POWER ERROR Press [CL] "
It indicates that the cash counter is improperly fed. Contact
RCH service centre to verify the feeder.
E63
“PRINTER ERROR Press [CL] "
It indicates anomalous printer operations. It may indicate the
incorrect closing of the upper part or that some connectors
are disconnected from the logic card. Should the problem
continue, contact RCH service centre.
E64
“HEAD UP [CL] "
It indicates that the replacement of the paper roll was
improper. Read again chapter 12 of the operating manual.
Should the problem continue, contact RCH service centre.
E65
"CUTTER ERROR [CL] "
It indicates the presence of paper stuck in the cutter. Remove
the paper and press CL . Should the problem continue,
contact RCH service centre.
70
E70
“LOW BATTERY [CL] ”
The battery is down; re-charge the battery and continue the
sales.
E80
"FISCAL MEMORY NOT CONNECTED"
It indicates that the fiscal memory is disconnected. Contact
RCH service centre to reinstate its working.
E81
“ERROR READ FISCAL MEMORY"
It indicates a problem to access the fiscal memory. Switch off
and switch on again the cash counter. Should the problem
continue, contact RCH service centre.
E82
“ERROR WRITE FISCAL MEMORY"
It indicates a writing problem onto the fiscal memory. Contact
RCH service centre.
E83
“FISCAL MEMORY FULL!"
It indicates that all the settings to zero available have been
completed (2000). Call RCH service centre.
E84
"FISCAL MEMORY NOT SERIALISED "
It indicates that it is not possible to subject the cash counter to
taxes, as fiscal memory has not the series number.
E85
“DISPLAY LCD NOT CONNECTED"
It indicates that the display is disconnected: Contact RCH
service centre to control the display.
E86
“ERROR MEMORY RAM."
There has been a malfunctioning on the cash counter RAM
memory. Contact RCH service centre to reinstate the system.
E87
“RAM ERROR / FISCAL MEMORY ”
There has been a malfunctioning between the cash counter
RAM memory and the fiscal memory. Contact RCH service
centre to reinstate the system.
Rel. MALTA 05/05 V.02
To Previous Page
