9
Fan Mode
Setting the Fan Mode
The FAN button controls the HVAC system’s MANUAL fan mode. The current manual fan mode is
displayed above the button, Auto or On.
Normally the FAN mode is in the Auto mode (the system fan is automatically controlled by HVAC system).
If you want the FAN on manually, select the ON mode. The fan will run continuously until it is turned off by
selecting AUTO mode.
In the main Thermostat Control Screen, press the FAN button to go to the FAN MODE selection screen,
as shown below.
Select the mode desired with the Up/Down buttons. Press the Done button to select and exit.
Fan Mode Screen
Select Fan mode with
Up or Down buttons.
Press DONE button to select mode and exit
back to main Thermostat Control Screen.
Pressing the FAN button will also step
through the fan modes.
To Next Page
Loading...
