Version Number: RBM-1350 20210712A2
Tips:
1. Wear a welding helmet fitted with a proper shade of filter to protect your face and eyes when welding or watching;
2. Wear approved safety glasses. Side shields recommended;
3. Use protective screens or barriers to protect others from flash and glare; warn others not to watch the arc;
4. Wear protective clothing made from durable, flame-resistant material(wool and leather) and foot protection;
5. Use approved ear plugs or ear muffs if noise level is high;
6. Never wear contact lenses while welding.
MIG mode （Self-protection mode of flux-cored welding wire）
RBM1350 provides only one welding modes: self-shielded welding with fluxed wire.
RBM1350 outstandingly supports 0.8mm and 0.9mm diameter welding wires, and automatically and intelligently
matches the best welding parameters according to different specifications of welding wires to achieve the best
results.
1. Connect MIG gun and ground clamp.
Note: No need to use gas cylinder and gas meter
2. Installation
Before connecting operation please make sure all the power is turned off.
To Next Page
Loading...
