Record Power BS250 - Page 10

3. Stand & Wheel Kit Assembly (Optional) - cont.
3.3 Wheel Kit Assembly
1. On the underside of the operating
frame, feed the short stem wheels
through the pre-drilled holes and secure
with one of the pins and washers
provided
Fig.3.9.
2. With the operating frame in hand,
attach the release pedal to the underside
of the operating frame using the 3
Phillips head bolts
Fig.3.10. The slots
on the release pedal are elongated to
allow adjustment when the wheel kit is
assembled.
3. Take the two long stem wheels and
pass them through the pre drilled holes
in the operating frame pedal and secure
with pins
Fig.3.11.
Now slide an axle through one of the
front legs and hook a brace support bar
on it. Place a washer on and slide a pin
through the axle end
Fig.3.12.
4. Pass the axle through the operating
frame pedal and through the opposing
leg. Once the axle is through the
opposing leg hook the remaining brace
support bar on the axle and secure with
a washer and pin as previous
Fig.3.13.
5. Now pass the remaining axle through
the rear of the stand and hook the brace
support bar with washer and pin as
previous.
Fig.3.14.
6. The operating frame can now be fitted
to the axle and secured to the opposing
rear leg with the other brace support
bar, washer and pin. Ensure when this
operating frame is fitted that it sits below
the operating frame pedal
Fig.3.15.
7. Slide the rubber feet onto the bottom
of the band
saw legs and position
the frame upright. Once the frame
is
upright, the whole assembly should fall
into place. However it will not operate
correctly until the actual bandsaw is
fitted. Fig.3.16.
Fig.3.9
Fig.3.11
Fig.3.13
Fig.3.10
RELEASE PEDAL
Fig.3.12
AXLE
WASHER
PIN
BRACE
SUPPORT BAR
Fig.3.14
Fig.3.15
Fig.3.16
OPERATING
FRAME
LONG STEM
WHEELS
OPERATING
FRAME PEDAL
BRACE
SUPPORT BAR
OPERATING FRAME
BELOW THE PEDA
L
OPERATING
FRAME PEDAL
RUBBER
FEET
AXLE