red lion T48 - Lockout Parameter Chart (3-LC); Lockouts Parameter Module (3-LC); Alarm Parameter Chart (4-AL); Alarm Parameters (4-AL)

CONFIGURE LOCKOUTS 3-LC
MNEMONIC PARAMETER USER SETTING
SP Access Setpoint
OP Access Output Power
dEv Access Deviation Display
Hcur Access Heater Current
UdSP Access Display Units
CodE Access Code Number
PId Access PID Values
AL Access Alarm(s) Values
ALrS Enable Reset Alarm(s)
SPSL Enable Remote/Local Transfer
trnF Enable Auto/Man Transfer
tUNE Enable Auto-tune
CONFIGURE ALARMS 4-AL
MNEMONIC PARAMETER USER SETTING
Act1 Alarm 1 Action Mode
rSt1 Alarm 1 Reset Mode
Stb1 Alarm 1 Standby Enabled
AL-1 Alarm 1 Value
Act2 Alarm 2 Action Mode
rSt2 Alarm 2 Reset Mode
Stb2 Alarm 2 Standby Enabled
AL-2 Alarm 2 Value
AHYS Alarm Hysteresis Value
CONFIGURE COOLING 5-O2
MNEMONIC PARAMETER USER SETTING
CYC2 O2 Output Cycle Time
GAN2 Relative Cooling Gain
db-2 Heat-Cool Overlap/Deadband
CONFIGURE SERIAL COMMUNICATIONS 6-SC
MNEMONIC PARAMETER USER SETTING
bAUd Baud Rate
ConF Character Frame Format
Addr Controller Address
Abrv Abbrev. or Full Transmission
PoPt Print Options
INP dEv
SEt OFP
OPr r_P
Pbd Crg
Int Cdb
dEr OSt
AL1 RSP
AL2 HCr
CONFIGURE REMOTE SETPOINT 7-rS / 7-n2
MNEMONIC PARAMETER USER SETTING
dSP1 Remote Setpoint Display Value #1
INP1 Remote Setpoint Input Value #1
dSP2 Remote Setpoint Display Value #2
INP2 Remote Setpoint Input Value #2
FLtr Remote Setpoint Filter Time Constant
bAnd Remote Setpoint Filter Band
trnF Local/Remote Transfer Options
CONFIGURE HEATER CURRENT INPUT 7-HC / 7-n2
MNEMONIC PARAMETER USER SETTING
Hcur Heater Current Readout Scaling
CONFIGURE SECOND LINEAR OUTPUT 8-A2
MNEMONIC PARAMETER USER SETTING
A2tP Second Linear Output Range
A2LO Second Linear Output Low Value
A2HI Second Linear Output High Value
-30-