38 | Display User Guide
SCREEN SETTINGS — TURN OFF DISPLAY KEY SOUNDS
1. On the RedVision
®
Display, use the Left Arrow Button ( ) to navigate to the setting screens, then use the
Up/Down Buttons (
/ ) to navigate to the Display Settings screen.
2. Press the Screen Settings Soft Key .
3. With Key Sound selected, use the Left/Right Buttons ( / ) to toggle key sounds Off/On.
4. To save, press the
Soft Key.
SYSTEM SETTINGS
System Settings allows for modication of the current operating mode as well as providing information on the
system and previous fault history.
System Mode
System Settings
Device Information
R-Bus Diagnostics
Fault History
SYSTEM MODE
The System Mode setting lets you set the Manager to operate in Storage or Touring Mode — default setting
(after startup or factory reset) the Manager will be set to Touring Mode.
Press the System Mode Soft Key
in the System Settings screen and use the Left/Right Buttons ( / )
to toggle between Touring and Storage mode. To save, press the
Soft Key.
Touring Mode — designed for use when 'on the road' for correct operation. In this mode the Manager will
monitor the auxiliary battery and detect certain faults, including short circuit, over current and over voltage.
Storage Mode — designed for medium to long term storage of the system. In this mode the charger will keep
your auxiliary battery at the optimum long‑term level. The charger will also conduct periodic maintenance on
the auxiliary battery including battery tests, desulphation, and equalisation depending on your congured
battery type. If Start Battery Charge mode is enabled, the Manager will also keep your start battery topped
up at a oat level during Storage Mode.
The Manager should be set to Storage Mode when you're no longer traveling. When in Storage Mode, it is
recommended to have a valid charging source to maintain the battery at a healthy state of charge — this
is achievable by using AC Mains or solar. Alternatively, disconnect all loads from your auxiliary battery and
check on your system periodically.
NOTE: If the Manager is set to Storage Mode, it will automatically switch to Touring Mode once it senses an
increase in input voltage from the start battery input.
To Next Page
Loading...
Need help?
General