Redarc TVMS Rogue - Installation - Mounting; Mounting Hardware

Installation — Mounting | 13
INSTALLATION — MOUNTING
MOUNTING HARDWARE
When mounting the TVMSRogue, any fasteners may be used so long as:
 They are suitable for the selected mounting surface and;
 They have a clearance-fit through the mounting holes on the Main Unit.
Using four screws/bolts from M6 (¼") to M4 (#8) with washers is recommended.
< 13 mm
< 1/2"
>13 mm
>1/2"
< 13 mm
< 1/2"
>13 mm
>1/2"
Apply washers.
If using countersunk fasteners, make sure
a countersunk washer is used with it to
avoid damaging the Mounting Holes.
Heads of fasteners and washers must not
exceed 13 mm (½") in diameter to avoid
deforming/damaging the plastic around the
Mounting Holes.