Redarc TVMS Rogue - Edit a Configuration

36 | System Configuration
EDIT A CONFIGURATION
1. Open the RedVision
®
Configurator App.
2. From the Choose System screen, tap Open Configuration
.
3. From the list, choose the configuration you want to edit.
4. Edit the configuration as required to suit your RedVision system — remember to tap Save
each time you make a change.
PROGRAM THE DISPLAY
Once you have finished editing your configuration, it is applied to the Display via the Program
function.
1. Open the RedVision
®
Configurator App.
2. From the Choose System screen, tap Open Configuration
.
3. From the Choose Configuration screen, tap the configuration you want to use to Program the
Display. The configuration menu will appear.
4. Tap Program
then choose your system from the list. The App will connect to the Display
and the programming process will begin.
The process takes approximately 1 to 2 minutes to complete — DO NOT close the App or
use other Apps or functions on your Smartphone while your RedVision
®
system is being
programmed.
5. When programming is complete, your smartphone will display a confirmation message, and the
Display will show the new configuration.
Failed to Program
If the Programming process fails, repeat the steps again before contacting REDARC. If it continues
to fail, contact REDARC directly, or your local REDARC Distributor.