Redarc TVMS Rogue - Compliance and Standards; Regulatory Compliance

Technical Specifications | 45
COMPLIANCE AND STANDARDS
TVMS ROGUE COMPLIANCE
Compliance and Standards listed are for the TVMSRogue only — For Regulatory and compliance
information for other products described in this manual, refer to the Instruction Manual supplied with
that product.
Regulatory
Safety EN 61010.1
Environmental RoHS and REACH compliant
REDVISION DISPLAY COMPLIANCE
To view regulatory and compliance information on the RedVision
®
Display, press the Power button
( ) to display the Power Control screen, then press the Compliance Soft Key (  ).
FEDERAL COMMUNICATIONS COMMISSION (FCC) STATEMENT
Part 15.105 NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
 Consult the dealer or an experienced radio/TV technician for help
This device contains FCC ID: XPYNINAB1
Details of the Responsible Party:
REDARC Corporation
1701 Northwest Highway, Suite 100
Grapevine TX
76051
USA
Phone: +1 (704) 247 5150