Redarc TVMS Rogue - Mounting Location

14 | Installation — Mounting
MOUNTING LOCATION
 Mount as close as possible to the auxiliary battery to avoid voltage drop. Refer to the 'Cable
Size Selection Table'(page27) for the correct cable size for your cable length.
 Do not mount the Main Unit to moveable panels in your vehicle.
 Do not mount the Main Unit using adhesives or adhesive tape.
 Mount the Main Unit permanently to a surface that has adequate strength and structure to
support it when all connectors and wiring are in-place.
 Mount in a location that is cool, i.e. avoid mounting in a full-sun position or next to devices that
emit heat. If the published thermal ratings (page44) are exceeded, the TVMSRogue may
automatically turn Off some or all outputs.
 Mount in a location that is dry and is not prone to high humidity. Liquid or vapour entering the
Main Unit can cause irreparable damage.
 Mount in any orientation except with the connectors facing upwards to prevent
condensation/liquids running into the Main Unit. For further advice, see 'Water Ingress
Avoidance'(page33).
 The mounting surface must be flat and safe to drill — check the reverse side before drilling.
Mounting orientation
Mount to a flat surface