Care and Maintenance | 41
CARE AND MAINTENANCE
Do not use solvents, alcohol, or domestic cleaning products to clean the TVMSRogue. If sand,
grit, or dirt accumulate on the Main Unit, wipe it clean with a slightly damp cloth.
Do not allow the TVMSRogue to come into contact with corrosive substances.
Periodically check that all connections are firm, and that all cables are adequately managed.
Parts of the system may have moved as a result of repeated vibration, particularly if the vehicle
has been travelling on uneven/corrugated road surfaces.
TROUBLESHOOTING
GENERAL TROUBLESHOOTING
If you experience any of the listed problems, follow the recommended actions in order until the
problem is resolved — all steps may not be needed to resolve the problem.
If the problem persists after completing all of the recommended actions, contact REDARC directly,
or your local REDARC Distributor.
The Status LED is flashing or solid red
There is a Fault. Refer to page41 for more detailed information and ways to identify and resolve
individual Faults.
The RedVision
®
Display will not connect to the RedVision
®
App/Configurator App
1. Make sure the smartphone is within 5metres (16'5") of the RedVision
®
Display.
2. Check that Bluetooth
is enabled on your device.
3. Remove the RedVision
®
Display 'DISP4300' from the Devices list in the RedVision
®
App and
also from the Bluetooth devices list in your smartphone settings.
4. Delete all pairings from the RedVision
®
Display. See 'Delete All Display Pairings'(page41).
5. Unplug all RJ45 R-Bus Cables from the RedVision
®
Display and then reconnect them again.
6. Turn your smartphone Off and then On.
7. Re-pair the RedVision
®
Display and smartphone.
Delete All Display Pairings
1. On the RedVision Display, navigate to Display Settings.
2. Press the Bluetooth
®
Soft Key ( ) to display the Bluetooth Pairing Advertising screen.
3. Press the Delete Soft Key (
) then press the OK Soft Key ( ) to confirm that you want
to clear all paired devices.
To Next Page
Loading...
