Redarc TVMS Rogue - End-User Lockout

System Configuration | 37
END-USER LOCKOUT
TVMSRogue allows you to add an Installer PIN (personal identification number) to prevent
end-users from changing the Configuration of their RedVision
®
system. This is to avoid safety
hazards if the system is reconfigured in an unsafe way by persons who do not fully understand the
system requirements.
IMPORTANT: By adding an Installer PIN, the saved Configuration cannot be edited without
entering a correct the PIN. DO NOT forget the PIN.
ADD AN INSTALLER PIN:
1. Open the RedVision
®
Configurator App.
2. From the Choose System screen, tap Open Configuration
then select the configuration
you want to add an installer PIN to.
3. Tap the gear icon (
) at the top right of the screen, then select Add Installer PIN from the
pop-up list.
4. Type a 4 to 8 digit PIN into the New PIN field, then retype it in the Confirm new PIN field. Tap
Add.
5. The pin will now have to be input in order to make any changes to the locked configuration.
REMOVE THE INSTALLER PIN:
1. Open the RedVision
®
Configurator App.
2. From the Choose System screen, tap Open Configuration
then select the configuration
you want to remove the Installer PIN from.
3. Tap the gear icon (
) at the top right of the screen, then select Remove Installer PIN from
the pop-up list.
4. Type the PIN into the Current PIN field, then tap Remove.