Reely 1611412 - 11 Resetting the Remote Control Binding

47
11. Resetting the remote control binding
To bind the quadrocopter to a new transmitter, for example after replacing the transmitter, follow the instructions
below:
Push the joystick for the pitch and yaw function (9) to the
lowest position.
Press and hold the photo function button (10) push button.
Press the on/off button (8) for at least 2 seconds.
The red LED on the transmitter (6) lights up and the trans-
mitter emits a short beep. Shortly after, the blue LED (5)
startstoashquickly.
Nowconnecttheightbatterytothequadrocopter.
The quadrocopter will now perform the switching on pro-
cess and, in the process, store the digital coding of the
transmitter. To indicate this, the quadrocopter and the
transmitter emit a short beep.
When the switching on process has been completed and the LEDs at the quadrocopter remain lit up, the quadrocopter
is ready for use with new binding.
Figure 8