Rev 19 Page58
7 UNIT IDENTIFICATION
7.1 Product ID Numbers
There are currently three versions of the FROG-3. The model numbers are:
FS-01 (320) Standard: Standard 3 passenger version with the facility to carry a stretcher.
FS-01 (340) Arctic: A low temperature version of FS-01, certified for use down to -40 deg C.
FS-01 (370) Tropical: Fitted with Tropical Feet formulae designed for higher longevity in high heat
and humidity conditions
7.2 Part Numbers
In the drawing / part numbering system, each assembly or part is assigned a three part number
which provides the unique identification of the part /assembly.
7.3 FROG-3 Serial Numbers
Every FROG-3 built is assigned a build serial number. These serial numbers are allocated sequentially
in the order in which FROG-3 units are built. Serial numbers start from FS-001, and continue in
numerical sequence. The serial number for each FROG-3 will be stamped on a plate, which is
attached to each unit.
7.4 Component Serial Numbers
Where material grades and material traceability are deemed to be safety critical these components
will be allocated unique component numbers which will be stamped or etched as required.
Components that require unique identification are referenced in the Parts List.
For bolts, where etching is impractical, batches of bolts will be colour coded and a note added to the
mill certificate to identify the colour coded bolts with a particular mill certificate.
To Next Page
Loading...