What to do if there is no AC power on my Regal 52 SC Boat?
D
devin06Aug 21, 2025
If there is no AC power on your Regal Boat, check if the main shore power breakers are tripped or in the “off” position and energize the shore power inlet breakers. Also, make sure the dock power is activated and the shore power cord is properly connected and locked. Inspect for any faulty connections and repair as needed. For earlier yachts, check the triple breaker at the output of the isolation transformer and reset the breakers if tripped. For later yachts, check the ELCI breaker and reset it if necessary.
N
nicholasedwardsSep 4, 2025
Why water does not enter bowl during flush in my Regal 52 SC?
H
Heidi ByrdSep 4, 2025
If water does not enter the bowl during flush or the water add cycle in your Regal Boat, check that the supply line is properly connected to the fresh water supply. Ensure that the circuit breaker has not tripped, and check all pump electrical connectors. Check the water supply valve at the manifold.
D
Dr. Patricia Hayes MDSep 2, 2025
What to do if the battery is not charging while the engine is running on my Regal Boat?
J
juliathomasSep 3, 2025
If the battery is not charging while the engine is running on your Regal Boat, check for a loose belt and tighten it.
N
Nathan NavarroSep 1, 2025
What causes excessive vibration in my Regal 52 SC?
S
Sharon CarrSep 1, 2025
If you are experiencing excessive vibration on your Regal Boat, check for any material obstructing the propeller and reverse the engines to remove it.
P
Paul RyanAug 30, 2025
Why is the engine speed/rpm low on my Regal Boat?
K
Kenneth BartonAug 31, 2025
If the engine speed/RPM is low on your Regal Boat, check for growth on the hull and clean the bottom if necessary. Inspect the fuel quality. Check for any accumulation of bilge water and check for leaks. Verify the trim tab is not in the “up” position and check trim tab functions/pump fluid levels.
M
matthew97Aug 29, 2025
How to troubleshoot no DC (12 volt) power on my Regal 52 SC?
D
danielchoiAug 29, 2025
If there is no DC (12 volt) power on your Regal Boat, verify that the battery switch is in the “on” position. If it is, check the battery condition. If the battery is weak or dead, charge or replace it.
C
Christopher JohnsonAug 27, 2025
Why is the 12 volt equipment not working on my Regal Boat?
H
hansonkentAug 27, 2025
If the 12 volt equipment is not working on your Regal Boat, ensure the equipment switch is in the “on” position. Check for blown circuit breakers and reset them. Verify the battery is not weak or dead, and replace it if necessary. Inspect for corroded connections and eliminate any corrosion. Tighten any loose wires. If there is an internal short, replace the equipment component.
D
Danny SmithAug 26, 2025
What to do if the toilet in my Regal 52 SC does not flush properly?
D
davidortizAug 27, 2025
If the toilet in your Regal Boat does not flush or the flush performance is poor, first, ensure the waste tank is not full. Empty the waste tank if the tank indicator light is red. Check for any clogs at the pump inlet and clear them. Also, ensure that there is no more than a 10% decrease in voltage when the macerator is running, as a larger decrease may indicate a wiring problem.
A
Andrew McconnellAug 25, 2025
Why is the refrigerator in my Regal 52 SC not cold?
K
Kyle LyonsAug 25, 2025
If the refrigerator in your Regal Boat is not cold, ensure the breaker is on at the main ship’s service panel. Check that the thermostat is properly set and the on/off switch is activated. Inspect the door latch and seal for proper closure; adjust the latch or replace the seal if needed. Clean the condenser coils with a brush or vacuum after removing the fridge.
E
Edward LopezAug 23, 2025
What to do if there is no power to AC outlets and/or equipment in my Regal Boat?
L
logan91Aug 23, 2025
If there is no power to AC outlets and/or equipment on your Regal Boat, first check if the main AC ship’s panel breakers are tripped or in the “off” position, and reset or activate them. Ensure the shore power cord is correctly connected. Also, check for tripped GFCI outlets and reset them after identifying and resolving the cause of the trip.
To Next Page
General
