46
Regency
®
P36D-1 Zero Clearance Direct Vent Gas Fireplace
INSTALLATION
WIRING DIAGRAMS
Caution: Ensure that the wires do
not touch any hot surfaces and are
away from sharp edges.
This heater does not require a 120V A.C. sup-
ply for operation. In case of a power failure, the
burner switch and the optional remote control/
thermostat will continue to operate. However,
a 120V A.C. power supply is needed for the
fan/blower operation.
(Do not cut the ground terminal off under
any circumstances.)
NOTE: Even if the fan is not purchased
with the unit, it is still a good idea
to bring power to the receptacle box
(provided with the unit) in case the
fan is installed at a later date.
CAUTION: Label all wires prior
to disconnection when servic-
ing controls. Wiring errors can
cause improper and dangerous
operation.
For NATURAL GAS Units and Units NOT Equipped with DC Spark Boxes
To Next Page
Loading...
