REMdevice t3 - Keeping the Radio Control Device in Good Working Order

Instruction Manual
Radio control devices T3, T5 and T7.
version 1.4 Genn. 10
KEEPING THE RADIO CONTROL DEVICE IN
GOOD WORKING ORDER
Clean the transmitter periodically to prevent the accumulation over
time of dirt which is difficult to remove and may cover the graphic
symbols on the control buttons.
If the symbols become illegible, or the adhesive labels come off, it is
recommended to apply new labels available from REMdevice.
Avoid using solvents to clean the device.
The transmitter must not be immersed in water.
Check the perfect seal of the transmitter gasket the absence of
cracks on the shells and the integrity of the rubber of the buttons.
Any liquid infiltrations may severely damage or jeopardise the regular
operation of the electric circuits inside the transmitter.
Special maintenance and repairs must be carried out only by
specialised personnel authorised by REMdevice.
Perform the controls as described in the chapter “Checking the
efficiency of the Stop/Emergency button and of the control buttons”.
Never use the appliance if the Stop/Emergency button is not
efficient.
The correct operation of the mushroom button ensures the
immediate stop of all the functions of the operating machine and the
deactivation of the radio control device. The breakage, even partial,
or the imperfect efficiency of this button endanger the safety of the
radio control device, making it no longer comply with the regulations.
Entrust reject material or the product to be scrapped to the
authorised disposal centres in your territory.
REMdevice
®
- ITALY page 17 of 28