2010 Release
E-58
- Cut right the exit of the silencer tubes starting from the bottom of the genuine
bevel :
Recovering distance in the duct
between 20 and 30 mm
- It is allowed to cut the screws in front of the duct to prevent from a possible
contact with the silencer tubes :
- Fit the diffuser on the car. Fasteners are the same as the ones used for the old
one (new fasteners included) :
4.7.5 FRONT HEADLIGHTS
The front headlights directly take place instead of the old ones.
- Change the plastic nut 77 03 081 222 on each side :
To Next Page
Loading...
