3
4
B
C
1
2
5
NU760_1_G3-FRA.qxd 9/11/05 17:18 Page 3.45
3.45
SLEEPSAFE HEADREST (continued)
For children
Lift lock 2, remove strap 3, then
close lock 2 down again. Completely
lower the padding B.
Place the child on the seat. The two
side retainers 4 should go each side
of the child’s neck. Then adjust the
headrest height: the base of the side
retainer 4 must be approximately
two centimetres from the shoulders.
For better comfort, feed the strap
into housing 5. The label C reminds
you how to proceed.
To refit the headrest
Lift lock 2, completely close the
padding B, engage the belt 3, then
push the lock 2 home to lock it.
Check that it is correctly locked in
position.
Sleepsafe headrest storage position
Press the headrest guide tab 1 and
lower the headrest completely.
The lowest position is for storage
only. It should no be in this position
when a seat is occupied.
The child headrest can be
used only with an
approved seat height
adjuster for categories 2
(15 to 25 kg) and 3 (22 to 36 kg).
Refer to the information on Child
safety in Section 1.
In any other case, padding B must
always be kept in the raised and
locked position.
NU760_1_G3-ENG.qxp 27-Dec-05 18:41 Page 3.45 (Black/Process Black plate)
To Next Page
Loading...
