1
4
5
NU760_1_G1-FRA.qxd 10/11/05 10:11 Page 1.72
1.72
EXTERIOR LIGHTING AND SIGNALS (continued)
Before driving at night: check
the electrical equipment is
operating correctly and,
depending on the vehicle,
adjust your headlights (if your
vehicle is not carrying its normal
load).
In general, check that the lights are
not obscured (by dirt, mud, snow or
objects which could cover them).
Main beam headlights
á
With the dipped beam
headlights on, pull the stalk towards
you.
When the main beam headlights are
on, an indicator light lights up on
the instrument panel.
To return to the dipped beam
headlight position, pull the stalk
towards you.
Switching off the lights
e
Turn the end of stalk 1 back
to its original position.
See me home lighting function
This function enables you briefly to
light up the dipped beam headlights
and is useful, for example, for
opening a gate, garage, etc.
With the ignition off and the
RENAULT card removed from the
reader, pull stalk 1 towards you: the
dipped beam headlights light up for
approximately 30 seconds.
This action may be carried out no
more than four times for a maximum
lighting period of two minutes.
Cancelling the function
To cancel the function:
- press button 4 again;
- press button 5.
Lights-on warning buzzer
A warning buzzer will sound when
a front door is opened and the lights
are left on after the ignition has been
switched off (to prevent the battery
from going flat etc.).
NU760_1_G1-ENG.qxp 27-Dec-05 18:37 Page 1.72 (Black/Process Black plate)
To Next Page
Loading...
