2.8
ENG_UD79435_2
Commande de vitesses (XFK - Renault)
Driving in mode B
By releasing the accelerator, the vehi-
cle uses regenerative braking to slow
down the vehicle. Thus the electric
motor generates an electrical current
which enables the traction battery to
be recharged. You can use this mode
to manually set the regenerative level
higher (B3) or lower (B1).
Note: with position D, B or R engaged,
when the vehicle is stationary, it sets off
at a low speed as soon as you release
the brake pedal (without pressing the
accelerator pedal).
Moving from position D to B
Move the lever to position D, move the
lever to the right to position B.
Position D corresponds to the regener-
ative level B2.
B2 is the default level.
To select level B1, push forwards. To
select level B3, push backwards.
GEAR CONTROL (3/5)
Driving in mode D
Put the lever in position D. In most traf-
fic conditions, you will not have to touch
the gear lever.
To select reverse gear
With the vehicle stationary and the
engine running, depress the brake
pedal and move the lever to position R.
The reversing lights will switch on as
soon as reverse gear is engaged (if
the ignition is on) and also the revers-
ing camera (depending on the vehicle)
➥ 2.129.
The instrument panel display indicates
the position B engaged along with the
regenerative braking level.
In position B, regenerative braking may
be reduced if the battery is cold and
fully charged.
Moving from position B to D
With the lever in position B, move the
lever to the left to position D.
B1
B2
B3
To Next Page
Loading...
