EasyManua.ls Logo

Renault RAFALE - Page 193

Renault RAFALE
406 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DRIVER CORRECTION DEVICES AND AIDS
3
Driving - 191
Hill descent control operates between
approximately 4 and 19 mph (6 and 30
km/h)inforwardgearandatapproxi-
mately 4 mph (6 km/h) in reverse gear.
Note: if the vehicle speed is above 37
mph(60km/h),thesystemisdeacti-
vated and the warning light
goes out.
Activating/deactivating the system
There are several activation methods
available to access the system:
via the "Hill Descent Control" widget
(if configured by the customer);
viathe"Favourites"function(ifcon-
figured by the customer) 🡺130;
depending on the vehicle, from the
"Vehicle" world
2
,select"Chassisdy-
namics"
3
, then press
4
. the
warninglightisdisplayedonthein-
strumentpanel.Todeactivatethefunc-
tion, press
4
again. The warning light
goesoutontheinstrumentpan-
el.
Starting the system
With the vehicle moving downhill, as
soon as sufficient gradient is detected,
the warning light turns to green.
During activation of the hill descent
control system, the descent speed can
be increased using the accelerator
pedal or decreased using the brake
pedal.
Each time the system is activated, you
mayhearthenoiseofthebrakingas-
sistance pump as it operates.
Note: this system does not function as
the gear lever is in P position or if the
vehicle is driving on a flat surface.
Operating faults
In the event of an operating fault, the
"Check HDC" message is displayed in
orange on the instrument panel.
If there is an operating fault, contact
an approved dealer.
If the system is unavailable, the "HDC
unavailable" message is displayed on
the instrument panel.

Table of Contents

Related product manuals