ADDITIONAL DRIVING AID FUNCTIONS
3
Driving - 233
brake your vehicle to a complete stop
before setting off again.
Important: you should
keep your feet near the
pedals and your hands
on the steering wheel at
all times to prepare for any event.
The system controls acceleration and
deceleration of your vehicle using the
engine and braking system.
TheStopandGoadaptivecruisecon-
trol function can be activated from 0
mph, according to conditions on the
road (traffic, weather, etc.).
It is represented by the 🡺252
symbol.
Note:
– thedrivermustobservethemaxi-
mum speed limit and safe distances
according to the legislation in the
country where they are driving;
– the adaptive cruise control can brake
the vehicle up to a third of the braking
capacity. Depending on the situation,
the driver may need to brake harder.
The Stop and Go adaptive
cruisecontroldoesnottrig-
ger an emergency stop and
its braking capability is limited.
The Lane Centring function
Using information from a camera, the
"Lane Centring" function manipulates
thesteeringsystemtodirectthevehi-
cle in the lane.
If the conditions allow it, the function is
available between:
– 0 mph and a speed between 99 mph
(160 km/h) and 112 mph (180 km/h)
(dependingontheversion)withavehi-
cle in front;
or
– 37mph(60km/h)andaspeedbe-
tween 99 mph (160 km/h) and 112
mph (180 km/h) (depending on the
version) without a vehicle in front.
The"LaneCentring"functionisacom-
fort feature.
It is represented by the warning
light.
Note: in the event of a sharp bend, the
function's lateral retention capacities
are limited and require the driver to
take immediate action on the steering
wheel.
Additional information
Depending on the vehicle, the "Active
driver assist" function may be used
with other driving aid functions.
Please note that:
– the system cannot be activated while
the "Hands-free parking" function is in
operation;
– When the "Lane Centring" function is
in adjustment mode, this will suspend
the "Lane departure prevention"func-
tion if it has already been activated.
When the "Lane Centring" function is
not controlling the steering system, the
"Lane departure prevention" function
may be reactivated if conditions allow.