ADAPTIVE CRUISE CONTROL
3
Driving - 261
any accessory fitted on the front of the
vehicle (on the grille), or hidden by any
accessoryfittedonthefrontoftheve-
hicle (on the grille or logo, etc.).
Conditionsincertaingeographicalar-
easmayhinderthefunction,forexam-
ple:
– arid zones, tunnels, long bridges or
lightly used roads without road lines,
without signs or trees nearby;
– a military or airport zone.
You must leave such areas in order for
the function to work.
In all cases, if the message is not
erased after the engine is restarted,
please contact an authorised dealer.
Temporaryunavailability(cam-
era)
Thesystemcannotoperateifthecam-
era is obscured (by dirt, mud, snow,
condensation, etc.).
Ifthevisibilityofthecameraisre-
duced, the performance of the Stop
and Go adaptive cruise control will be
reduced. Remain vigilant.
Operating faults
If an operating fault is detected on the
Stop and Goadaptive cruise control
function, the "Check adaptive cruise
control"messageappearsonthein-
strument panel and the Stop and Go
adaptivecruisecontrolfunctionisin-
terrupted.
If an operating fault is detected on one
or more of the system components,
theStopandGoadaptivecruisecon-
trol function is interrupted.
Depending on the type of malfunction,
themessageisdisplayedonthein-
strument panel:
– "Checkfrontcamera"messageac-
companied, depending on the vehicle,
by the warning light ;
– "Checkfrontradar"messageaccom-
panied, depending on the vehicle, by
the warning light ;
– "Checkcamera/radar"messageac-
companied, depending on the vehicle,
by the warning light ;
– "Checkvehicle"messageaccompa-
nied by the warning light .
Consult an approved dealer.
Limitations of system operation
Vehicle detection
The system detects only vehicles
(cars, trucks, motorbikes) that are
moving in the same direction as your
vehicle.
A vehicle turning into the same lane
(e.g.
L
) will be taken into account by
the system only once it enters the
camera and radar detection areas.
The system may trigger inappropri
ate or delayed braking.