Figure 4-4: Connect the devices
8. Check the IP address of the PLC (Figure 4-5):
o Change to “Device view”
o Choose the PLC device
o Click on the PLC in the “Device view”
o The IP address in the “General” window must be the same as set in the PLC
Figure 4-5: Check the IP address
9. Set the name of RZ/N1 (Figure 4-6):
o Double click on your network interface card (in “Project tree” > Online access)
o Open “Online & diagnostics” of the RZ/N1 device
o Go to the function setting “Assign Name”
o Change the device name
o Press “Assign name” button
To Next Page
Loading...
