2 Features
The port GmbH’s PROFINET device stack is a fully implemented Conformance Class A PROFINET stack. It
has no feature restrictions but in demonstration mode it only runs about 3 hours. Using the SNMP stack
Conformance Class B is also possible.
It contains but is not restricted to the following features:
• Alarms
• Diagnosis
• Cyclic data exchange up to 1 ms cycle time (depending on the application)
• Acyclic data
• Unrestricted record data access (depending on the application)
• Neighbourhood detection support
• DCP support (station name, IP configuration, factory reset)
• LLDP support
• Examples with ready to run projects
• Callbacks for various PROFINET events
• Dynamic module plug and pull support / dynamic device configuration
• Supported by the port GmbH PROFINET I/O Config Tool
To Next Page
Loading...
