RZ Family / RZ/G, RZ/A Series 2. Functional Specifications
R01UH0990EJ0101 Rev.1.01 Page 38 of 83
Jul 28, 2022
Table 2.2 List of Pin Function Selection Used on Each Module Board (14/18)
1.1V
Note: Unused in case of RZ/Five
Connected to PMIC, used as
NRESET function
Unused
Note: In case of RZ/Five,
this pin is used as
WDTOVF_PERROUT
#. Mounted a resistor
(R79) for WDTOVF
option and connected
to a logic IC for using
NRESET function of
PMIC, but the WDT
function is not
available at this time.
QSPI Flash (IC9) or OctaFlash (IC2)
and OctaRAM (IC3)
QSPI Flash (IC9) or OctaFlash (IC2)
and OctaRAM (IC3)
QSPI Flash (IC9) or OctaFlash (IC2)
and OctaRAM (IC3)
QSPI Flash (IC9) or OctaFlash (IC2)
and OctaRAM (IC3)
QSPI Flash (IC9) or OctaFlash (IC2)
and OctaRAM (IC3)
QSPI Flash (IC9) or OctaFlash (IC2)
and OctaRAM (IC3)
Carrier Board Connector, connected
to 24pin FFC/FPC connector for
MIPI-CSI (CN1)
Carrier Board Connector, connected
to 24pin FFC/FPC connector for
MIPI-CSI (CN1)
Connected to 45pin FFC/FPC
connector
Carrier Board Connector, connected
to PMOD1 connector (J2) and Audio
Codec (IC2)