Changes to specification
Renishaw plc may modify or change its products or specifications without notice and
without obligation.
Warranty
This document defines the procedure for fault finding and repairing TSA returned to
the OEM after expiry of the warranty.
This document is to be used in conjunction with Renishaw parts supplied in the
Repair Kit (A-2116-0131).
Renishaw plc cannot take responsibility for any Renishaw product repaired by the
OEM.
The OEM may only repair Renishaw product if its warranty has expired.
Equipment requiring attention under warranty must be returned to your supplier. No
claims will be considered where Renishaw equipment has been misused, or
unauthorised persons have attempted repairs or adjustments.
PRECAUTIONS
Safety
Remove power before performing any maintenance operations.
Only competent persons observing relevant safety precautions may carry out repairs.
Anti static handling
The electronic circuit board assemblies within the TSA and those supplied in the
Repair Kit are sensitive to static discharge.
Anti static precautions must be observed during handling or installation of the
electronic circuit board assemblies. Failure to do so could result in permanent
damage to the electronics.
Product integrity
The torque wrench settings defined in this manual ensure the integrity of sealing
elements and fixings within the TSA.
Failure to use these settings when repairing TSA could result in coolant ingress or
poor repeatability.
To Next Page
Loading...
