5-4
Setting up the ventilator for use
Assemble the patient circuit, including the main flow (inspiratory) bacteria
filter, proximal pressure line, oxygen sensor tee, and if desired, humidifier and
nebulizer. Figure 5-2 and Figure 5-3 show circuit configurations for
noninvasive and invasive ventilation. Follow the manufacturers’ instructions for
use for the individual parts.
NOTE: This circuit setup is recommended for noninvasive ventilation. It is
also recommended for high flow therapy when using the AC611 high
flow nasal cannula with FEP Connector to block the exhalation port.
Figure 5-1: Noninvasive patient circuit, with heated-wire and humidification
Proximal pressure line
Ventilator
outlet
Bacteria filter
Proximal
pressure
port
Humidifier
Oxygen sensor tee
To Next Page