Revitive Medic Coach - Operation and Program Troubleshooting

54
Revitive is not
vibrating.
REVITIVE IS NOT DESIGNED TO VIBRATE.
Revitive is not
"rocking".
It is the muscles in your legs
that cause the “rocking”, the
IsoRocker® is a pivot.
Revitive will only rock when
increased to an intensity which
causes suicient calf muscle
contraction. It may be that you
cannot comfortably increase the
intensity high enough until you get
used to the sensation. It is important
that the intensity is adjusted to a
level that is manageable.
Revitive is too far in front
of you.
Sit with your knees at a 90 degree
angle.
When Revitive is
rocking on a hard
floor it makes a
tapping noise.
Incorrect positioning of
Revitive or too high an
intensity level.
Adjust the positioning of Revitive or
lower the intensity level to reduce
Revitive tapping. Alternatively use a
floor mat under Revitive to cushion
the sound.
My legs are aching
aer treatment.
You may have set the
intensity
too high and your muscles are
being overworked.
Leave adequate time aer each
treatment to allow the muscles
to recover (just like aer vigorous
exercise!). On your next session start
on a lower setting (where you can
feel the mild electrical stimulation
and it is comfortable) and reduce
the duration until your muscles have
acclimatized to the stimulation.
When using the
electrode pads, the
stimulation feels
uncomfortable.
The level of stimulation you
are using may be too high or
you may have broken skin.
Decrease the stimulation level using
the intensity control on the app or
the intensity control on Revitive.
You may need to discontinue use
until your skin has healed.
I am unsure which
program is selected.
The selected program is displayed at
the top of the Controller screen.
I suddenly can’t feel
stimulation when
using the electrode
pads
You may have accidentally
paused the stimulation session
either by disconnecting a pad,
a cord or by pressing the pause
button.
When the stimulation is paused,
sections of the display on the app
and Revitive pulse. The app will
be showing the Start or Stop
buttons. Tapping resumes the
stimulation and tapping ends the
stimulation session. You will need
to re-connect the pads to your body
or re-connect the cord to be able to
resume.
Problem Possible Cause Solution
Troubleshooting