5
Specifications
For Battery types: Lithium Polymer HV (1s to 6s balanced, 1s to 2s unbalanced), Lithium
Polymer (1s to 6s balanced, 1s to 2s unbalanced) Lithium Ion (1s to 6s balanced, 1s to 2s
unbalanced), Lithium Manganese (1s to 6s balanced, 1s to 2s unbalanced), A123 (LiFePO4)
(1s to 6s balanced, 1s to 6s unbalanced), NiCd (1s to 19s), NiMH (1s to 19s), Lead Acid
batteries (1s-12s Flooded, Gel, AGM, SLA)
Pack capacity: 50 mAh to 360Ah
Input voltage: 10-32VDC, reverse polarity protected
Input current: 1A to 40A, software limited
Power conversion: Synchronous DC/DC converter, 85% to 93% efficiency depending on
output current
Output battery charge current: Adjustable range 25mA to 40A, limited by 40A input current*
Output battery discharge current: Internal discharge 25mA to 8A, 50W max. Regenerative
discharge 25mA to 40A, 1000W max
Continuous max output power: 408W @ +12VDC input, 1000W @ +30VDC
Cell balancing: 1s-6s Li or A123 (LiFePO4) balanced charging
Voltage calibration: Cell voltage measurements are factory calibrated to a standard traceable
to NIST; calibration is to +/- 6 mV
Current calibration: Charge current is factory calibrated on a 4A standard; calibration is to +/-
1mA
Measurement accuracy:
Voltage resolution: 78uV (16 bit)
Voltage tolerance: +/- 6mV
Charge current: +/- 1%
Capacity added to pack: +/- 1%
Percent capacity (“Fuel”): +/- 5% (with accurate fuel table defined for battery being charged)
Interface: USB 2.0 Full Speed (12Mb/s)
Cooling fans: Single, 13 CFM, 50mm diameter
Heat sink: Internal 120W aluminum, thin finned
Output battery connector: Modified JST XH series, 7 position max; accepts 1s-6s balance
plugs on batteries
LCD: 2.6", 128 x 64 pixels graphic LCD with white LED backlight
Size: 5.70" x 5.57" x 3.40"
Footnotes:
* Please note, for safety reasons, available charger current may be limited for certain battery
types and/or charging modes, e.g., non-balanced charge of Li
To Next Page
Loading...
Need help?
General
