Setup Steps:
1. Open the smart driving application and turn on BSD (Blind Spot Detection).
The button turns from gray to blue.
2. Click to enter BSD setup interface. Click the option Warning Speed
and select the appropriate option (a default value can be used). The Warning
Speed means that when any vehicle is detected within the set warning range, an
alarm is activated if the driving speed of the car is greater than the set value.
3. Click the option Warning Sensitivity and select an appropriate option (a
default value can be used). Warning Sensitivity means that when any vehicle is
detected within the set warning range, an alarm is activated if the driving speed
of the following vehicle is greater than that of the car. High: An alarm is
activated regardless of car speed. Moderate: An alarm is activated if the
following vehicle has a speed 10km/h greater than the car. Low: An alarm is
activated if the following vehicle has a speed 20kg/h greater than the car.
To Next Page
Loading...
