REXROTH A2FO Series - Ordering Code and Standard Program

2/20 Bosch Rexroth AG | Mobile Hydraulics A2FO | RE 91 401/09.00
Ordering Code / Standard Program
(Ordering code size 5 see page 7)
A2F O / 6 –
Sizes 5...200: production Elchingen plant; sizes 250...1000: production Horb plant
= available
– = not available
1
) only in connection with drive shaft bearings "L"
2
) threads of fixing screws are metric
= preferred program
(preferred types see page 18)
Hydraulic fluid
Mineral oil (no code)
HFB-, HFC-, HFD- sizes 10...200 (no code)
fluids sizes 250...1000
1
) E-
Axial piston unit
Bent axis design, fixed displacement A2F
Drive shaft bearings 10...200 250..500 710..1000
Mechanical bearings (no code) –
Long-Life bearings – L
Mode of operation
Pump, open circuit O
Size
Displacement V
g
(cm
3
)
5 10 12 16 23 28 32 45 56 63 80 90 107 125 160 180 200 250 355 500 710 1000
Series
6
Index
sizes 10...180 1
size 200 3
sizes 250...1000 0
Direction of rotation
Viewed on shaft end clockwise R
anti-clockwise L
Seals 10...200 250...1000
NBR (nitril-caoutchouc) – P
NBR (nitril-caoutchouc), shaft seal in FKM (fluor-caoutchouc) – N
FKM (fluor-caoutchouc) V
Shaft end 10 12 16 23 28 32 45 56 63 80 90 107 125 160 180 200 250 355 500 710 1000
Splined shaft ––––– A
DIN 5480 – – – – – –– Z
Parallel shaft with – ––––– B
key, DIN 6885 – – – – – –– P
Mounting flange 10 12 16 23 28 32 45 56 63 80 90 107 125 160 180 200 250 355 500 710 1000
ISO 4-hole –––– B
ISO 8-hole ––––––––––––––––– H
Service line connections
2
)
A(B) SAE, at side
––– ––––05
S SAE, at rear
A(B) threads at side
––––––––––––––––––06
S threads, at rear
A(B) SAE, at rear
––––––––––––––––– 11
S SAE, at rear