Preparing the Machine
52
2
F
FF
F
Click [Browse].
G
GG
G
Select the printer driver you want to use.
If the CD-ROM drive is D, the source files of the printer driver are stored in
the following location:
• RPCS
D:\DRIVERS\RPCS\WIN2K_XP\(Language)\DISK1
• PCL 6
D:\DRIVERS\PCL6\WIN2K_XP\(Language)\DISK1
• PCL 5e
D:\DRIVERS\PCL5E\WIN2K_XP\(Language)\DISK1
• PostScript 3
D:\DRIVERS\PS3\WIN2K_XP\(Language)\DISK1
H
HH
H
Click [
Open
].
I
II
I
Click [
OK
].
J
JJ
J
Follow the instructions.
When installation is complete, the printer connected to "1394_00n" appears in
the [Printers] window. ("n" shows the number of printers connected.)
Note
❒ If the printer driver has already been installed, the printer icon is added to
the [Printers] window. In this case, printer driver installation is not neces-
sary.
❒ If printing does not work properly after the installation, delete the port and
reinstall the printer driver. For details, see "Printer Does Not Print", Main-
tenance Guide.
❒ If you do not want to install the printer when Found New Hardware Wiz-
ard starts under an operating system that supports SCSI print, disable the
device by following the procedure below.
A
When the [Found New Hardware Wizard] dialog box appears, click [Next>].
B When the message "This wizard will complete the installation for this
Device: Unknown" appears, select the [
Search for a suitable driver for my de-
vice recommended] check box, and then click [Next>].
C When the message "Please choose your search and installation option."
appears, clear all check boxes from [
Search for the best driver in these loca-
tions.], and then click [Next>].
D When the message "Driver Files Search Results" appears, select the [Dis-
able the device. The Add/Remove Hardware Wizard in the control Panel can be
able to complete the driver installations.
] check box, and then click [
Finish
]."
MartiniC25-GB-Pref-F7_FM.book Page 52 Tuesday, November 9, 2004 3:46 PM
To Next Page
