3. Enter the horizontal size of the original with the number keys, and then press [ ].
4. Enter the horizontal size of the copy with the number keys, and then press [ ].
5. Enter the vertical size of the original with the number keys, and then press [ ].
6. Enter the vertical size of the copy with the number keys, and then press [ ].
7. Press [OK] twice.
• You can enter sizes between 0.1 and 99.9 inches in increments of 0.1 inches.
•
To change the value you entered, press the key you want to change, and then enter a new value.
• The machine selects reproduction ratios of between 25 and 400%.
• When entering a size in inch, if the calculated ratio is over the maximum or under the minimum
ratio, it is automatically adjusted to within available range. However, with some ratios, parts of the
image might not be copied or margins will appear on copies.
Create Margin
Reduces the image to 93% of its original size and places the reduced image at the center. By combining
it with the Reduce / Enlarge functions, you can further increase a margin.
1. Press [Create Margin].
2. Select the reproduction ratio, if necessary.
3. Advanced Copying
122
To Next Page
Loading...
