1. Press [New Job] when "Copying..." appears.
2. Be sure message "Ready" appears, and then make settings for the next copy job.
3. Place the originals, and then press the [Start] key.
All originals are scanned.
When the preset job is complete, a job preset confirmation dialog box appears.
4. Press [Exit].
The initial copy display appears.
After the current copy job, the next copy job starts automatically.
• You can switch the display to the current copy job by pressing [To Copying Screen]. You can
switch the display to the preset job by pressing [To Reserv. Screen].
•
Preset copy jobs are registered under job numbers in the Reserv. Screen.
• You can confirm and delete preset jobs. For details about the procedures, see “Managing Jobs”.
• p.93 "Managing Jobs"
2. Basic Copying
36
To Next Page
Loading...
