Basic Delivery Procedure
81
3
H If necessary, select [Sender's Name] under [Options], and then specify the
sender.
The sender you specify appears in the subject line of e-mail that is sent via the
delivery server. Select the sender from the destinations registered on the de-
livery server. For details, see "Specifying the Sender".
I If necessary, select [Attach Subject] under [Options], and then specify the subject.
The subject entered here is set for e-mail that is sent via the delivery server.
For details, see "Specifying the Subject".
J Press the {Start} key.
Scanning starts.
You must press the {q} key to send scan files that are scanned from the ex-
posure glass.
Scan files that are scanned from the ARDF are sent immediately.
K If you still have originals to send, place them on the machine, and then
press the {Start} key.
Repeat this step until all originals are scanned.
L After all originals are scanned, press the {q} key.
Transmission starts.
Note
❒ To send e-mail via delivery server, press [Manual] on the delivery screen,
and then enter a destination e-mail address. For details about the proce-
dure for manually entering e-mail addresses, see "Manual Entry of an E-
mail Address".
❒ If you have selected two or more destinations, the destinations can be
made to appear one by one by pressing the {U} or {T} key.
❒ To cancel a selected destination, display the destination in the destination
field, and then press the {Clear/ Stop} key.
❒ You can use the Return Receipt function when sending e-mail via delivery
server. An e-mail is sent to the sender selected in step
H
, notifying him/her
that the recipient has read his/her e-mail. For details about the procedure
for setting the Return Receipt function, see "Setting the Return Receipt
Function".
To Next Page
Loading...
