Delivering Scan Files
82
4
Preparing to Deliver a File
This section describes the preparations and settings for delivering scan files.
Important
❒ To use the network delivery scanner, you need a delivery server on which an
application such as the optional the ScanRouter delivery software is installed.
For details about the ScanRouter delivery software, see the manuals supplied
with the ScanRouter delivery software.
❒ To view files delivered to an in-tray, DeskTopBinder must be installed on the
client computer.
A Connect the machine to the network.
Connect the machine to the network using an Ethernet cable or IEEE 1394 ca-
ble, or wireless LAN (IEEE 802.11b).
B Make the necessary network settings in [System Settings].
If you have connected the machine to the network using an Ethernet cable,
make the following settings. For details, see General Settings Guide.
• Specify the machine’s IPv4 address and subnet mask
•In [Effective Protocol], enable [IPv4]
•Set [Delivery Option] to [On]
C If necessary, change settings in [Send Settings] under [Scanner Features].
D Using the ScanRouter delivery software, register this machine as an I/O de-
vice. In addition, specify register destinations and specify such settings as
the delivery type and sender.
For details, see the manuals supplied with the ScanRouter delivery software.
Note
❒ To connect the machine to the network using an IEEE 1394 cable or wire-
less LAN (IEEE 802.11b), an extended 1394 board or extended wireless
LAN board is required respectively. For details, see Network Guide.
❒ Items to set up in [System Settings] vary depending on the network environ-
ment. For details about the network settings, see General Settings Guide.
❒ For details about installing DeskTopBinder Lite, see "Installing DeskTop-
Binder Lite from the Supplied CD-ROM".
Reference
p.83 “Installing DeskTopBinder Lite from the Supplied CD-ROM”
To Next Page
Loading...
Need help?
General
