Problem Cause Solution
White lines appear. When is blinking, toner is
beginning to run out.
Add toner. See p.83 "Adding Toner".
Copies are blank. The original is not set
correctly.
When using the original table, face the
originals down.
A moiré pattern is produced
on copies.
Your original has a dot
pattern image or many lines.
• Change the orientation of the
original. This may prevent the
moiré pattern.
• Copy using “Photo” mode.
Wrinkles appear on the copy. The paper is damp. • Replace the paper with new paper.
• To prevent paper absorbing
moisture, turn on the anti-humidity
heater switch. See “Guide to
Components”, About This
Machine.
When You Cannot Make Clear Copies
27
To Next Page
Loading...
