Problem Cause Solution
You cannot combine several
functions.
Selected functions cannot be
used together.
Check the combination of functions and
make the settings again. See “Function
Compatibility”, Copy/Document
Server Reference.
Images are skewed. The side fences in the cut
paper tray are not set
properly.
Make sure the side fences are set
properly. For details about how to set the
side fences, see p.81 "Changing the
Paper Size".
Images are skewed. The paper is feeding in at a
slant.
Load the paper correctly. See p.77
"Loading Paper".
Images are skewed. The original was not set
straightly.
Set the original so that it is squarely
aligned with the original guides.
Original and copy size does
not match.
Dampness can cause paper
to stretch.
Adjust the Fine Magnification setting for
Additional Copy. See “Fine
Magnification”, Copy/Document
Server Reference.
Cannot scan originals on
mixed A series and JIS B
series paper continuously.
Originals on different series
of paper cannot be scanned
continuously at the same time.
Scan the originals on each series
separately.
The machine does not start
copying even though you
have inserted paper into the
bypass tray.
Originals are not scanned. After scanning the originals, load paper
in the paper bypass.
Copies shift sideways. The paper roll is not set
correctly.
Set the paper roll correctly, making sure
it is straight and not loose. See p.77
"Loading Paper".
Copies shift sideways. The original does not match
the size in the original table
setting.
Adjust the original guides to the
specified size, and then insert the
original along the guides. See “Placing
Originals”, Copy/Document Server
Reference.
When You Cannot Make Copies As Wanted
29
To Next Page
Loading...
