Problem Cause Solution
Cannot specify folding. The paper tray setting in the
printer driver's Printer
Properties dialog box is set to
[Auto Tray Select] or [Bypass
Tray].
Select Tray 1, 2, 3, or 4.
Cannot specify folding. Translucent paper or film was
specified.
Translucent paper and film are not
available for folding. They are delivered
to the upper output stacker, but not
folded. Select another paper type, and
then specify folding.
"Please wait." appears on the
display panel and printing
cannot be done.
The folding finisher is offline. Turn off the main power switch of both
the machine and folding finisher, and
then turn them back on again in the
following order: folding finisher, and
then the machine.
Then check the folding finisher is online.
Other printing problems
Problem Cause Solution
It takes a long time to
complete a print job.
“Sleep mode” might be set. The machine requires time to warm up if
it has been in “Sleep mode”. In [System
Settings], under [Timer Settings], select
[Auto Off Timer], and then specify
“Sleep mode”.
It takes a long time to
complete a print job.
The paper type setting was
changed.
If the paper type setting has been
changed, there might be a delay before
printing begins. Wait for a moment.
Other Printing Problems
57
To Next Page
Loading...
