Specifies the reception speed for the fax modem.
Default: [33.6 Kbps]
• 33.6 Kbps
• 14.4 Kbps
• 9.6 Kbps
• 7.2 Kbps
• 4.8 Kbps
• 2.4 Kbps
• JBIG
Enables transmission and reception of JBIG-compressed images, which require less
communication time than MMR-/MR-/MH-compressed images.
Note that to use this function, [ECM Transmission] and [ECM Reception] must also be
enabled.
This function is not available with Internet Fax.
Default: [Active]
• Active
• Inactive
Report Print Settings
• Print TX Status Report
Sets the machine to print a transmission report automatically after a fax transmission.
When the machine is in Immediate Transmission mode, the image of the original will not be
reproduced on the report, even if [Error Only (Image Attached)] or [Every TX (Image
Attached)] is selected.
The transmission report will be printed using the tray set for [Facsimile] under [Paper Tray
Priority] in system settings, on A4 or Letter size paper.
Default: [Every TX (Image Attached)]
• Error Only
Prints a report when a transmission error occurs.
• Error Only (Image Attached)
Prints a report with an image of the original when transmission error occurs.
• Every TX
Prints a report for every fax transmission.
• Every TX (Image Attached)
Prints a report with an image of the original for every fax transmission.
7. Configuring the Machine Using the Control Panel
270
To Next Page
Loading...
