Ricoh D255-17 - Page 878

Error Codes
D255/D256 FAX OPTION 44 SM
Code Meaning Suggested Cause/Action
22-02
TX or RX job stalled due to
line disconnection at the other
party
 The job started normally but did not finish
normally; data may or may not have been
received fully.
 Restart the machine.
22-04
The machine cannot store
received data in the SAF
 Update the ROM
 Replace the FCU.
22-05
No G3 parameter confirmation
answer
 Defective FCU board or firmware.
23-00
Data read timeout during
construction
 Restart the machine.
 Replace the FCU.
25-00
The machine software resets
itself after a fatal transmission
error occurred
 Update the ROM
 Replace the FCU.
F0-xx V.34 modem error  Replace the FCU.
F6-xx SG3 modem error
 Update the SG3 modem ROM.
 Replace the SG3 board.
 Check for line noise or other line problems.
 Try communicating another V.8/V.34 fax.