3-2-2. Pick-up and Feed Rollers
1.
2.
3.
4.
5.
6.
7.
Remove the ADF clutch (see section 3-2-
1).
Remove the lower ADF guide plate [E] (4
screws); see the diagram on the previous
page.
Remove E-rings and bushings [F].
Remove spning [G].
Remove the pick-up roller [H] (1 E-ring)
and feed roller [I] (1 E-ring).
If it is necessary to disassemble the one-
way clutch [J], see the diagram.
Reassemble the machine.
Caution: Do not touch the rubber surface of
the new rollers, or document feed
problems will occur sooner than
normal.
3-4
To Next Page
Loading...
