5-5. Defective Sensor Table
Sensor
Symptoms if shorted
Symptoms if open
Document sen- “PAGES:00 KPAD/N”, “DEPTCODE 0000
“READY SET DOCUMENT” remains
sor (SB-1) KPAD/N”, or “QUICK/SPEED/KPAD” are
displayed even if a document is
displayed even if no document is present. present.
Scan line sensor
At power up, the default contrast, resolu-
A document jam occurs half-way
(SB-2)
tion, and reception mode indicators blink.
through feeding the first page.
Trailing edge
Operation appears normal. Tx/copying is normal until the end.
sensor (SB-0) However, the machine does not send
an end of page signal (the other ter-
minal does not cut the paper be-
tween pages).
Printer jam sen-
At power up, a paper cycle is made, then
At power up, a paper cycle is made
sor (SB-5)
CLEAR COPY is displayed even if there is but the paper is not cut, and CLEAR
no jam.
COPY is displayed.
Paper end sen-
At power up, a paper cycle begins even if
The Replace Paper indicator lights at
sor (SB-4) there is no paper, but it fails and CLEAR
power up, even if paper is present
COPY is displayed.
Cutter sensor At power up, a paper cycle is made, then At power up, the cutter motor starts
(SB-7)
the cutter motor rotates a few times, then
immediately and rotates a few times.
CLEAR COPY is displayed.
Cover switch
CLOSE COVER is not displayed even if the CLOSE COVER is displayed even if
(SB-10)
cover is opened.
the cover is closed.
5-25
To Next Page
Loading...
